Inches to Feet Converter

The converter above is already set to inches and feet, so you only need to enter your number. The result updates as you type, and nothing is sent anywhere.

1. Type your value in the Value box, for example 72. Decimals and negative numbers are accepted.
2. Check that From shows inches and To shows feet. Both menus can be changed if you need a different pair.
3. Read the answer in the large result box. The note under it shows the exact factor used for one inch.
4. Press Copy result to put the answer on your clipboard, or Swap units to convert in the opposite direction.
5. Look at In every unit on the right to see the same amount in all the other length units.

One inch is about 0.0833333 feet, so the formula is feet = inches x 0.0833333. Going the other way, one foot is exactly 12 inches. The inch has been defined as exactly 25.4 millimeters since the international yard and pound agreement of 1959. A foot is 12 inches, which is exactly 0.3048 meters.

Worked examples with the same factor:

• 72 inches: 72 x 0.0833333 = 6 feet
• 180 inches: 180 x 0.0833333 = 15 feet
• 720 inches: 720 x 0.0833333 = 60 feet

Divide by 12: every full 12 inches is one foot, and the leftover inches are the remainder.

To check the converter by hand, take 180 inches and apply the rule once: the result should be 15 feet. If you go back again with the reverse factor 12 you land on 180 inches, which confirms that the two directions agree. Rounding the factor to fewer digits for mental math gives a result that is close but not identical, so use the tool when the last digits matter.

These reference values come from the same factor the converter uses, so they match what you see above. Use the table for common amounts, and the converter for anything else.

Length units come from two families. The metric units (millimeter, centimeter, meter, kilometer) are powers of ten apart, so moving between them only shifts a decimal point. The customary units (inch, foot, yard, mile) descend from older body-based and road measures and were fixed to the meter by international agreement in 1959, which is why every conversion between the two families has an exact factor.

Use the table as a sanity check rather than a substitute for the converter. If your number sits between two rows, the answer must sit between the two results, and if it is ten times larger the answer is ten times larger. That simple scaling rule catches most typing mistakes, such as an extra zero or a misplaced decimal point.

Heights, room dimensions and lumber lengths are often measured in inches and then described in feet, as when 72 inches is called a six foot door.

Check which unit the number belongs to before you type it. Tape measures are marked in both systems, and a value read from the wrong edge is off by a factor of about 2.5. When a measurement will be cut, keep at least two decimals until the final step.

Related pages: Feet to Inches Converter for the reverse direction, and the feet to centimeters and meters to feet pages. For other length units use the length converter.

The page keeps no history, so each visit starts again from the defaults, 72 inches. Your numbers are processed by JavaScript in your own browser and are never sent to a server, which makes the converter safe for private figures such as medical, financial or work measurements.